Board Mounted Manifolds
This has become a favorite with our customers. We mount the manifolds, pump, and controls on a piece of 3/4" melamine. We Pre-Assemble, Pre-Plumb and Pre-Wire the manifold and controls - test for pressure and electrical - then shrink wrap and box it for shipment. This option can save hours of time plus it makes a very good looking assembly.
Simply hang the board on the wall beside the heater, hook to heater with 3/4" Pex (furnished), attach your heating loops, attach thermostat wires, fill with water and plug in.
All of our radiant floor heating manifold & control packages come with the control panel and the pump wired with plug-in cords attached. This allows you to plug the heating system into a small generator during power outages plus it allows you to replace the circulating pump without rewiring. In case of a control panel or zone valve failure the pump can be plugged into the wall to bypass the controls
These solid brass manifolds are self-purging and the insert/compression style fittings require no special tools for making your connections.
Manifolds Features
- Your manifold won't tarnish or corrode, it's made of solid cast brass. We customize your manifold and control assembly per your project requirements.
- Each loop has its' own flow control adjustment for balancing and can be isolated if necessary.
- Connections are simple and require no specialized tools. Simply insert the PEX and tighten the compression nut.
- Manifolds are self-purging.
- Actuator valves are low voltage and slow to open. This eliminates noise from water hammer and reduces power consumption.
- High-Efficiency, High-Head, High Quality Pump features an easy to replace cartridge for easy future maintenance. It's virtually silent and pre-wired to simplify your radiant heating installation.